Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| roi_analysis_with_lvis [2023/05/08 17:51] – created felix | roi_analysis_with_lvis [2023/05/09 10:19] (current) – felix | ||
|---|---|---|---|
| Line 12: | Line 12: | ||
| ==== Critical Level (Detection Threshold) ==== | ==== Critical Level (Detection Threshold) ==== | ||
| ==== Detection Limit ==== | ==== Detection Limit ==== | ||
| + | ===== Setup of a NaI Detector for ROI Analysis in LVis ===== | ||
| + | ==== Configuring the digiBase with MCB Properties and Maestro ==== | ||
| + | ==== Installing LVis & configuring the Detector ==== | ||
| + | ==== Configuring a new detector in LVis ==== | ||
| + | ==== Defining the QA Settings for a new ROI Detector ==== | ||
| + | ===== Defining ROIs ===== | ||
| + | ===== Calibrating the Detector for ROI Analysis ===== | ||
| + | ==== Defining Calibration Sources ==== | ||
| + | ==== Setting up the energy calibration parameters and performing an energy calibration ==== | ||
| + | === Setting up the energy calibration === | ||
| + | === Performing an energy calibration === | ||
| + | ==== Performing a gain stabilization check ==== | ||
| + | ==== Setting up the ROI efficiency calibration parameters ==== | ||
| + | ==== Performing an ROI efficiency calibration ==== | ||
| + | ===== Defining ROI Counting Routines ===== | ||
| + | ==== Initializing ROI Counting Routines ==== | ||
| + | ==== Executing ROI Counting Routines ==== | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||